Sam Naprawiam Skoda Octavia To Doc Manual Is Intended

Disconnect oil return-flow line for turbo- charger from engine -arrow-. 1.9-ltr.66 kW (TDI) Engine, Mechanical Components; Repair Group 21; Charge air system for turbocharger Use V.A.G 1669 or commercially available 6 mm wrench socket to remove screw for joint flange of right output shaft.

Sam Naprawiam Skoda Octavia To Doc Manual Is Intended

The Service Manual is intended only for use within the Skoda Organisation; it is not permitted to pass it on to Printed in CR third persons.

S00.5130.53.20 2002 KODA AUTO a.

K Location on gearbox Code letters and date of manufacture (arrow 1) Manual gearbox 02C 4WD (arrow 2) K Manual gearbox 02C 4WD (arrow 2) K Code letters and date of manufacture of gear-.

If a dynamometer for a 2WD vehicle is used, 1 to 2 brake tests can be performed with the ignition switched on and the engine not run- ning.

Different tolerances make it pos- sible to exactly gauge the required shim thick-.

Advantages: stepless distribution of force between front and rear wheels short response time of the Haldex coupling individual adaptation of the four-wheel drive.

Drive off slowly; only the front wheels should rotate when this is done.

These measured values supply information regarding the operating state of the system or of the sensors connected.

In many cases, the measured values transmitted can be used as an aid in fault finding and in rectifying faults.

Raise vehicle. Separate the plug connection at the rear fi-.

Switch ignition on.

Current Flow Diagrams, Electrical Fault Finding and Fitting Locations binder Notes: If readout is.

Drive off slowly; the rear wheels must be felt to start off when this is done against the force of the handbrake.

II - Assembly overview - gearshift lever Setting shift mechanism page 34-13.

Separate exhaust system at the double clamp -2- and remove together with catalytic converter (2nd person required).

Repair Group 26; Removing and installing parts of the exhaust system.

If the gearbox has been replaced, ensure that the intermediate plate is correctly located.

Check whether dowel sleeves for centering enginegearbox are present in the cylinder block.

Repair Group 26 of the particular engine Inspect gear oil in manual gearbox with bevel page 34-31.

Inspecting 5th speed synchronizer ring Before re-installing selector gear and synchronizer ring of 5th speed, press.

Engage 2 gears before tightening the bolts attaching 5th gear synchroniser body and sliding gear (arrows) page 34-38, Fig.

If da- maged, replace guide sleeve With seal Knocking out seal Fig.

Knocking in seal Fig.

Disassembling and assembling input shaft: 5-Speed Manual Gearbox 02J; Repair Group 35; Disassembling and assembling input shaft Edition 11.99.

Replacing seal for left flange shaft Special tools, testers and aids required Assembly device MP 9-501 Extraction hook MP 3-41937.

Pack space between sealing lip and dust lip half-full with grease G 052 128 A1.

Disconnect oil return-flow line for turbo- charger from engine -arrow-.

W (TDI) Engine, Mechanical Components; Repair Group 21; Charge air system for turbocharger Use V.A.G 1669 or commercially available 6 mm wrench socket to remove screw for joint flange of right output shaft.

Sam Naprawiam Skoda Octavia Pdf To Doc